|
Posted by Richard on February 24, 2001 at 11:25:02:
In Reply to: TypeII systems and Winscan 780 posted by Gary George on February 24, 2001 at 11:19:44:
1. Press MENU.
2. Go to 3: TRUNK DATA.
3. Press SELECT.
4. Enter the bank for the system you want to program in.
5. You should now see TRUNK TYPE - press SELECT.
6. Roll down to 4:TYPE II UHF and press SELECT.
7. For BASE CONFIG 1, press SELECT and enter the base freq (ex: 406.0) and hit ENTER.
8. For SPACE FREQ. 1 enter the spacing (ex: 25) hit ENTER.
9. For OFFSET, leave it as is at CH380 - hit ENTER.
10. Press MAN to get out of the menu.Thats about it - if your base and spacing are right, it should go. UNLESS the system has more than one base freq - in which you would need to know the offset and spacing to set up BASE CONFIG 2. But probably not, since it is a MIL 400 MHz system.
|
